Page top


Omron uses cookies to improve your experience on this website. By continuing to use the website, you hereby agree to our Privacy and Cookie Policy

Lead Contents

Connect PLC via Ethernet Using CX-Programmer

FAQ No. FAQ00258

Primary Contents


Using CX-Programmer FA Integrated Tool Package, how can we connect Programmable Controller via Ethernet?


1. Personal Computer Ethernet setting by IP Address and Subnet Mask.

2. Ethernet Unit: IP Address, Node No., Unit No.

3. CX-Programmer and CS1 Programmable Controller is connected with Tool bus Cable.

4. CX-Programmer I/O table Window: Unit Setting (CPU bus unit System Setting) is required to be set for Ethernet [IP Address Conversion] by Automatic generation, [Sub net mask] is set.

5. CX-Programmer (CX-Net): FINS Local Routing table is created and transferred to CS1.

6. Personal Computer issues PING Command to check if Ethernet connection is OK.

7. CX-Programmer Communication Setting

1) Personal Computer Model Change / [Network Type] is set [Ethernet].

2) Click [Setting], set FINS destination address [Network] / [Node]
(Node = Ethernet Unit Node Number, Network = Network address set in Routing table)

3) Check Automatic generation method at [Driver] tab / Workstation node Address. Port Number = 9600.